Anatomy of a painting | Bruce Herchenrader
This photo is taken from the vantage point of the first portage around the rapids on the Quetico River in Quetico Park. The view is looking back towards where the Quetico River empties into Beaverhouse Lake.
The rapids depicted here in this photo are where the Quetico River tumbles into Beaverhouse Lake, one of the westernmost lakes in Quetico Park. I've done about twenty trips over the years into this wilderness area being…
The drive to Quetico has stretched what I see as subject matter. Traveling the more than a thousand kilometers from my home in Southern Ontario to paddle the wilderness preserve of Quetico takes has allowed me to see so…
Oil, Canvas, 48 inches x 72 inches. Anatomy Of An Oil Painting "The Poet Falls" from photographic subject matter to finished painting Contents Introduction to colour palette............................................…
p.MsoNormal, li.MsoNormal, div.MsoNormal { margin: 0in 0in 0.0001pt; font-size: 12pt; font-family: "Times New Roman"; }div.Section1 { page: Section1; } Painting classes, lessons and books are not only about painting. Th…
The Sky 1 The first step is to mark on the canvas using a pencil where your horizon line will be. A general rule of thumb to follow is one third, two thirds. That means, that one third of your canvas is sky, two thirds…
There are two waterfalls in this painting so when painting trees and waterfalls I will refer to them as the trees behind or beside either the right or left waterfalls. Mix the green colour for the underpainting of green…
This quantity will not be enough to cover the whole area to be underpainted with this colour but you can mix more using the same formula. If you feel you can paint more then the first suggested quantity would paint then…
Now we are ready to paint the detail, the light and shadow of the trees. Paint small sections at a time, as it requires concentration. Mix a small amount of green that is midway between the lightest and darkest colour o…
The colours I mixed for the underpainting for the rock surface to the right of the falls was a dime size quantity of titanium white, a touch of raw umber or sepia, a touch of raw sienna and a touch of Paynes gray. Mix t…
We will mix a half dime of burnt umber and an equal amount of cobalt blue, mix thoroughly, add a quarter dime size quantity of paynes gray, add a touch of Windsor red, add a touch of burnt sienna, mix thoroughly, add a…
p.MsoNormal, li.MsoNormal, div.MsoNormal { margin: 0in 0in 0.0001pt; font-size: 12pt; font-family: "Times New Roman"; }div.Section1 { page: Section1; } The alkyds although drying faster then straight oil paints do take…
Our first layer of paint for the waterfalls is now dry. Mix the same colours as we mixed for the underpainting for the waterfalls in much smaller quantities. Study photograph of falls and add detail. It does not have to…
The waterfall will be painted in three steps. Using a pencil draw a light outline for the waterfall. Outline the darker area of the water at the crest of he waterfalls before it breaks into a white froth. Scrape any dry…
In the second step of creating the rock we use the wooded handle scrub brush to stipple texture over the previously painted gray surface
We will be using straight titanium white for this. Squeeze a quarter size quantity of white onto the palette. Mix with a half cap of taltine. This will create a not quite transparent layer of white. Using green painters…
Mix a half dime of Paynes gray and a half dime of burnt umber. Mix thoroughly. Thin with a quarter cap full of Taltine. Spray the area as in step one and add this layer of gray. Repeat step one and add another layer of…
For the rust stain on the rock mix a quarter dime of burnt sienna, add a dash of raw umber and a smaller dash of cadmium medium yellow and Windsor red. Using a number three brush fill the rusty stain area in and then fe…
Oil, Canvas, 42 inches x 72 inches x 2inches. The water mirrors the sky so we will start with an underpainting of blue that is composed of the same colours we used for the sky. Mix a half dime sized quantity of both cer…
Oil, Canvas, 42 inches x 72 inches x 2inches. finished underpainting for water.
Oil, Canvas, 42 inches x 72 inches x 2 inches. When mixing larger amounts of pigment use either the palette knife or those old brushes that have the worn exploded ends to them. Don't ruin the points on your new brushes.…
Oil, Canvas, 42 inches x 72 inches. In The Poet Falls 27 I got a little ahead of myself when I was adding touches of dark highlights to the rock surface previously painted and painted some of the area that we are now go…
Oil, Canvas, 42 inches x 72 inches. In The Poet Falls 28 I have added titanium white in splotches and then blended it into the gray underpainting. You can see in this progression that I have my photographic studies tape…
spray or splatter colour onto painting
When you have added a layer of white splatter then mix a quantity of gray by combining a half dime quantity of burnt umber, the same of cobalt blue, a quarter dime size quantity of paynes gray, mix thoroughly and add a…
Oil, Canvas, 42 inches x 72 inches x 2 inches. I used the cracks in the rock to divide this area into three sections, painting them a section at a time. I mixed a half cap full of taltine with a quarter size quantity of…
Oil, Canvas, 42 inches x 72 inches x 2inches
Oil, Canvas, 42 inches x 72 inches x 2 inches. When we paint the water we will be using two different colour palettes. When painting the white water turbulence we will use primarily white with very thin glazes of a mixt…
Oil, Canvas, 42 inches x 72 inches x 2 inches. Underpaint the areas of white water with the white. Mix a quarter dime size quantity of raw sienna, a touch of the cadmium yellow, burnt umber and sap green. Mix thoroughly…
Oil, Canvas, 42 inches x 72 inches x 2inches
Oil, Canvas, 42 inches x 72 inches x 2 inches. When painting the river if you work on it a small section at a time instead of the whole area it will be less daunting. I use a white conte pencil which you can find in mos…